January 14, 2008, 07:07:07 PM by admin.

From Wikipedia, the free encyclopedia.

Full Story | | Send To Friend | 168 views

Water Damage Restoration Basics

January 14, 2008, 06:34:57 PM by admin.

From Wikipedia, the free encyclopedia.

Full Story | | Send To Friend | 207 views

H.R. 5040: The United States Toxic Mold Safety and Protection Act

October 01, 2007, 10:31:48 PM by admin.

The Melina Bill

**UPDATE** H.R. 5040 died in the 107th Congress. It's original 30 sponsors are having a difficult time finding support for the bill. It is imperative that we contact our local representatives if you feel it is important to you and your family's health and safety. IAMM (http:www.moldorganization.org) is attempting to push sponsors for the 108th Congress.

Full Story | | Send To Friend | 186 views

Prevention and Remediation Strategies for the Control and Removal of Fungal Growth

October 01, 2007, 10:18:39 PM by admin.

Source: Department of Health and Human Services - Cernters for Disease Control and Prevention

Full Story | | Send To Friend | 220 views

Moisture and Mold Prevention and Control Tips

April 30, 2007, 08:44:44 PM by admin.

Moisture Control is the Key to Mold Control

Source: U.S. Environmental Protection Agency

•When water leaks or spills occur indoors - ACT QUICKLY. If wet or damp materials or areas are dried 24-48 hours after a leak or spill happens, in most cases mold will not grow.

•Clean and repair roof gutters regularly.

•Make sure the ground slopes away from the building foundation, so that water does not enter or collect around the foundation.

•Keep air conditioning drip pans clean and the drain lines unobstructed and flowing properly.

•Keep indoor humidity low. If possible, keep indoor humidity below 60 percent (ideally between 30 and 50 percent) relative humidity. Relative humidity can be measured with a moisture or humidity meter, a small, inexpensive ($10-$50) instrument available at many hardware stores.

•If you see condensation or moisture collecting on windows, walls or pipes ACT QUICKLY to dry the wet surface and reduce the moisture/water source. Condensation can be a sign of high humidity.

Full Story | | Send To Friend | 230 views

Mold Remediation or Repair

April 30, 2007, 08:31:47 PM by admin.

In some areas throughout the country, mold in homes has become a growing concern. A small leak or a major flood can trigger an outbreak. According to the Environmental Protection Agency (EPA), molds are a natural part of the environment. Molds produce microscopic cells called "spores" which are very tiny and spread easily through the air. When excessive moisture or water accumulates indoors, mold growth will often occur, particularly if the moisture problem remains undiscovered or unaddressed.

Full Story | | Send To Friend | 244 views

Hidden Mold

April 30, 2007, 08:30:28 PM by admin.

Source: U.S. Environmental Protection Agency

Suspicion of hidden mold

You may suspect hidden mold if a building smells moldy, but you cannot see the source, or if you know there has been water damage and residents are reporting health problems. Mold may be hidden in places such as the back side of dry wall, wallpaper, or paneling, the top side of ceiling tiles, the underside of carpets and pads, etc. Other possible locations of hidden mold include areas inside walls around pipes (with leaking or condensing pipes), the surface of walls behind furniture (where condensation forms), inside ductwork, and in roof materials above ceiling tiles (due to roof leaks or insufficient insulation).

Full Story | | Send To Friend | 227 views